Vertex Kits|Jeep Wrangler Unlimited 2WD/4WD (07-18)

Run up to 33-inch tires quickly and easily with Rough Country's 2.5-inch Coil Spring Suspension Lift. This easy to install lift features 100% bolt-on installation for a lightning fast install with no cutting or drilling required! Gain increased ground clearance with a set of front and rear factory-tuned coil springs based on the JK's stock spring rate.

This kit also includes a set of our Off-Road ready N3 Shock Absorbers, built 50% larger than standard shocks for all-terrain action!

Variant: 2.5 Inch Lift Kit|Vertex|Coils SKU: 67950-DHTP

Features:

• Easy bolt-on installation Increased ground clearance Clears up to 35" tires Factory tuned coil springs are based on the stock spring rate

Notes:

• Does NOT fit 4-door (Unlimited) models
• 35" tires will clear but rubbing may occur with extreme articulation If planning on running 35" tires on factory wheels, double check clearance between the front tire, lower control arm and sway-bar links
• 2012-2018 models require exhaust modifications to clear the front driveshaft (#1030)

Variant: 4 Inch Lift Kit|Vertex|X-Series SKU: 67450-DHTP

Notes:

• Does NOT fit 2-door models
• 2012-2018 models require exhaust modifications to clear the front driveshaft (#1030) On Automatic equipped vehicles; due to use of an oversize driveshaft from the factory and inadequate factory clearance it may be possible for the front driveshaft to come in contact with the automatic transmission pan tearing the factory boot and rubbing on the shaft
• Generally this occurs during heavy articulation when front sway bar links are disconnected and longer shocks are installed
• If this is found to occur, the proper procedure would be to replace the oversize factory shaft with an aftermarket smaller diameter shaft to increase clearance between the transmission and front driveshaft
• Rough Country does offer this driveshaft if needed

Variant: 6 Inch Lift Kit|Vertex|X-Series SKU: 68350-DHTP

Notes:

• Does NOT fit 2-door models
• 2012-2018 models require exhaust modifications to clear the front driveshaft SKU: 1030
• Due to insufficient length it is REQUIRED to replace the factory driveshafts
• 2007-2011 replacement driveshafts available HERE
• 2012-2018 replacement driveshafts available HERE